The HomePro ZDP100 plug-in Lamp Module is a component of the HomePro lighting control system. Plug the Lamp Module into a wall outlet and plug a lamp into the Lamp Module. Inclusion of the Lamp Module on the HomePro ZTH100 Wireless Controller menu allows remote ON/OFF control and dimming of lamps connected. This plug-in Lamp Module is designed to work with other HomePro lamp and appliance controls. Z-Wave nodes of other types can be added to the system and will also act as repeaters if they support this function of repeating the signal received to other modules in the system. As part of a HomePro network, the HomePro ZDP100 can act as a wireless repeater to insure that commands intended for another device in the network are received. This is useful when the device would otherwise be out of the radio range of the wireless controller. There are no field repairable assemblies on this unit. It is covered by a one year limited warranty. If service is needed, the unit must be returned where purchased.

Plug this Lamp Module into the wall outlet near the lamp to be controlled, and plug the lamp into the Lamp Module. See the ZTH100 Wireless Controller operating instructions to add this module under the command of the Wireless Controller. Make sure the lamp(s) to be controlled total no more than 300 watts. WARNING: Plugging a non-resistive load such as flourescent lighting or a device with a motor may result in damage to the Lamp Module and will void the warranty.

Lamp Module Button
The Lamp Module has a button on the face (see picture above) that switches an attached lamp ON and OFF, and adjusts its dimming level by holding it down, and it is also used to configure the module to operate from the wireless controller. With the Wireless Controller, the Lamp Module can be switched ON and OFF, and can be included in groups of lights (a group can also be a single module) that operate at the same time, and in scenes that set a lighting mood.

Switch power ON and OFF locally
When the button is pressed and released quickly, the power will toggle. This means that power will be turned OFF if it was ON and turned ON if it was OFF. When switching the Lamp Module ON or OFF, the light will dim UP (or DOWN) in approximately 2 seconds until the final level is reached.

Dimming
If the button is constantly pressed the light will be dimmed. The dimming function will also toggle. Constantly pressing the button the Lamp Module will dim either UP or DOWN until it reaches the maximum or minimum value. The second time the button is held down, the dimming will change direction. When the power level reaches either full power or minimum power the dimming will stop until the button has been released and is pressed again.

Child Protection
The Lamp Module can be set in a child protect mode by the Wireless Controller. When this mode is active, a user will have to press the button on the Lamp Module 3 times rapidly to activate the attached load. The module operates normally when controlled by the Wireless Controller.