Your shopping cart is currently empty. Please continue shopping - as there is nothing to check out
|
US2-V0 Anywhere Switches: - Built-in thermal overload protection for added safety - Patented heat sink design ensures cool operation and long life - Replaces existing mechanical switch and uses same wires - white neutral wire connection required - Controls incandescent, fluorescent, halogen, LED, magnetic and eletronic low-voltage lighting transformers ballasts Circuit Requirements: - Hot and neutral (black and white wire) power connections are required at both switch locations. - Controls incandescent, fluorescent, halogen, LED, magnetic and electronic low-voltage lighting transformers & ballasts (1 Watt Min., 900 Watts Max.). Ballas s for 120VAC Metal-halide or Mercury/Sodium fixtures may need to be isolated (see model: ZNF10A). Controls 120 VAC/60Hz motors up to 7.5 Amps Max. - Up to 4 Anywhere 3-Way Switch Kits and accessories can be used in a home, using the 4 available communication channels. - Installation of both switches should be on the same circuit (breaker) for maximum communication distance. If switches are on different circuits, they should be on the same phase power, i.e., both switches on phase A, or phase B circuit breakers. - If using both phase A and B circuits,and the home has more than 1 breaker panels or is more than 2500 sq. ft, phase coupler is recommended for optimum performance, (see model ZPCI). - Not intended for use in 3-phase (commercial/condo) applications unless the switches are on the same breaker or phase
|
The Simply Automated Anywhere 3-Rocker Wall Switch replaces a traditional wall switch for almost any lighting fixture to provide both local control over the connected light, as well as remote control over the other Simply Automated Anywhere devices (sold separately) in your home set to Channels 1, 2, and 4 (see details below). The switch can also respond to remote Anywhere commands from other Anywhere transmitters, allowing you to add remote control to the connected light.
- Main top rocker turns on/off local light plus Anywhere devices on Channel 2
- Bottom-left rocker turns on/off Anywhere devices on Channel 1
- Bottom-right rocker turns on/off Anywhere devices on Channel 4
- Adds remote control to light by responding to Anywhere transmitters
- Easily replaces a traditional wall switch
- Supports most lighting types up to 900 Watts
Using the existing fixture wiring, the switch's main top rocker can control incandescent, fluorescent, halogen, LED, magnetic, and electronic low-voltage lighting transformers and ballasts up to 900 Watts (minimum 1W). The blue-green LEDs indicate the light's on/off status.
The top rocker can also be used to control all Anywhere devices set to Channel 2. The bottom-left rocker controls all Anywhere devices set to Channel 1, while the bottom-right rocker controls Channel 4. You could set only one device to Channel 1, for example, to control just that device, or you could set a group of devices to Channel 1 to control an entire scene with just one switch.
It is important to note that the top rocker not only controls Channel 2, but is also set to respond as a Channel 2 device. Therefore, if more than one of these US2-V0 Series Switches is installed in a home, every Channel 2 rocker will control all of these switches' local loads simultaneously.
The Anywhere Series is not compatible with any of Simply Automated’s PC-Configured, Pre-Configured, Simply Smart TM, or other UPB or UPStart configured products.
